Forums » News and Announcements
Steps for proper installation and maintenance of 24 volt
-
The correct installation and maintenance of planetary gear motor is the key to the normal operation of planetary gear motor. Therefore, when you install a planetary gear motor, be sure to install it carefully in the following installation sequence.
Step 1: Before installation, verify that the motor and 24 volt servo pmdc motor wholesale are intact and damaged, and that the dimensions of each component adjacent to the drive motor and reducer are correct. This refers to the size and co-movement between the positioning boss and shaft diameter of the drive motor flange and the positioning slot and aperture of the reducer flange; Wipe and treat common appearance dirt and burrs.
Step 2: Unscrew the screw plug on the process hole on the side of the reducer flange, rotate the input end of the reducer, align the inner hexagonal nut with the process hole, and insert the grip hex screw loosened by the east-west rotation of the inner hexagon.
Step 3: Hold the drive motor so that the keyway on the shaft is perpendicular to the screw in the reducer input end hole, and insert the drive motor shaft into the reducer input end hole. When inserted, the two tubes must be concentric and parallel to the sides of the flange. It seems that the cause of such differences in the degree of heart, or the indomitable behavior of double-sided flanges, must be found. In addition, the use of hammering is strictly prohibited when placed, that is, the axial or radial force of hammering can be prevented from destroying the bearings of the two, and the consistency of the two can be judged by the feel of the device. The key to the common concentricity and parallelism of the two flanges is that after the two are inserted into each other, the two flanges are basically close and the holes are equal.
Step 4: For whether the two flanges of the packaging tube are continuous and evenly balanced, first tighten the fastening screw of the driving motor arbitrarily, but do not tighten it; Then gradually tighten the four fastening screws diagonally; Tighten the input hole at the end of the planetary gear motor to secure the screw. First tighten the screw that drives the motor, and then tighten the input hole of the reducer to secure the screw. Detail: The precise placement between the reducer and the unit equipment deployment is similar to the precise placement between the planetary gear reducer and the drive motor. The key is to align the planetary reducer output shaft with the input shaft of the driven unit. With the continuous growth of the application of control motor, the application of planetary gear motor in the field of motion control drive will also be more and more.
24 volt servo pmdc motor wholesale https://www.dydzmotor.com/63ZY105-PMDC-Motor.html